• Pressure clamp connectors
• Dynamic heating up
• Wide voltage range
• Energy saving
• Clip fixing
• Quick installation
These heaters are used in enclosures where damage from condensation must be prevented, or where the temperature
may not fall below a minimum value. The aluminium profile heater body design has a chimney effect and distributes
the heat evenly. The heaters are designed for permanent operation. Pressure clamb connectors save time and simplify
installation.
NTL 156Operating voltage120-240V AC/DC¹ (min. 110V, max. 265V)Heating elementPTC resistor - temperature limitingHeater bodyextruded aluminium profle, anodisedConnection3 pressure clamps for stranded wire 0.5-1.5mm2 (with wire end ferrule) and
rigid wire 0.5- 2.5mm2Connection casingplastic according to UL94 V-0, blackMountingclip for 35mm DIN rail, EN 60715Fitting positionvertical airfow (air outlet up, connection on bottom)Operating/Storage temperature-45 to +70°C (-49 to +158°F)Operating/Storage humiditymax. 90% RH (non-condensing)Protection type/Protection class
IP20 / I (earthed)Accessoires
screw fxing, Art. No. 09024.0-00 (1 packing unit = 2 pieces)
Note
other voltages on request