SAE1045/S45C Medium Carbon Steel for plastic mouldAISI 1045 steel is a medium tensile steel supplied in the black hot rolled or normalized condition. It has a tensile strength of 570 - 700 MPa and Brinell hardness ranging between 170 and 210.Itis characterized by good weldability, good machinability, and high strength and impact properties in either the normalized or hot rolled condition.
MachiningGood machinability in normalized as well as the hot rolled condition. based on the recommendations given by the machine manufacturers, operations like tapping, milling, broaching, drilling, turning and sawing etc. can be carried out on AISI 1045 steel using suitable feeds, tool type and speeds.WeldingAISI 1045 steel is readily welded when correct procedure is followed.
Welding AISI 1045 steel in through-hardened, tempered and flame or induction hardened condition is not recommended.
Low hydrogen electrodes are preferred for welding AISI 1045 steel.Heat TreatmentForging
Annealing
Normalizing
Stress relieving
Hardening
Tempering
Chemical compositionCr + Mo + Ni = max 0.63 C Si Mn Ni P S Cr Mo0.43 - 0.5max 0.40.5 - 0.8max 0.4max 0.045max 0.045max 0.4max 0.1
Application
Use for making injection plastic mould,mould frame and some middle-range machine.
1)Widely used in machine manufacturing;
2)For shaft parts ;
3)Stamping die drawing parts repair and hardfacing;Quality Contation of our steel products
1)Both end of each bar must be cut
2)Ladle furnanced and vacuum de-gassed
3)Show heat No. on each bar
4)Surface condition the surface of the hot rolled square bar shall befree cracks, scar and wrinkles that affect the use of the billets. In case there is the above-mentioned defect, it shall be remove.
5)The mill test certificate shall show the chemical composition, and it is guaranteed that the chemical composition shall be within the limit stipulated in the contract.Product pictures:
Corner of factory: